Skip to content

Outboard Shaft Lengths Explained: Short vs. Long

Table Of Contents

Outboard Shaft Lengths Explained: Short vs. Long

Find the exact measurements and learn how to choose the right outboard motor for your boat’s transom.

The Quick Answer (Industry Standards)

When you see “Short” or “Long” shaft, it refers to the boat’s transom height it was designed for, not the exact length of the metal stick.

  • Short Shaft (S): Designed for a 15-inch (38 cm) transom. The actual physical shaft length is usually around 16.5″ to 17.5″.
  • Long Shaft (L): Designed for a 20-inch (51 cm) transom. The actual physical shaft length is usually around 21.5″ to 22.5″.

The Science: What Exactly Are We Measuring?

If a Short Shaft is for a 15-inch boat, why is the motor itself 17 inches long?

The physical length of an outboard is measured from the inside top of the mounting bracket (the part that rests on top of the boat’s transom) down to the anti-ventilation plate (the large flat plate right above the propeller).

The Extra 1-2 Inches: Engineers design the shaft to be slightly longer than the boat’s transom. This ensures that when the boat is moving, the anti-ventilation plate sits completely flush with the bottom of the hull. This allows the propeller to run in clean, undisturbed water, preventing “ventilation” (the propeller sucking in air, which causes loss of power and engine damage).

How to Measure Your Boat

Stop guessing the motor size and measure your boat instead. It only takes one minute:

  1. Make sure your boat is resting on a level surface.
  2. Take a straight tape measure.
  3. Place the top of the tape at the top-center of your transom (exactly where the motor bracket will sit).
  4. Measure straight down to the very bottom of the hull (the lowest point of the keel).

If it measures ~15″, buy a Short Shaft. If it measures ~20″, buy a Long Shaft.

How to measure a boat transom for Yamabisi outboard motor

Actual Physical Shaft Lengths by Major Brands

While all brands target the 15″ and 20″ industry standards, their exact physical measurements (from bracket to anti-ventilation plate) vary slightly. Here is a comparison of major outboard brands:

Outboard Brand Short Shaft (S)
Fits 15″ Transom
Long Shaft (L)
Fits 20″ Transom
Yamaha Approx. 17.1 inches Approx. 21.6 inches
Mercury Approx. 17.3 inches Approx. 22.5 inches
Honda Approx. 17.0 inches Approx. 22.0 inches
Suzuki Approx. 16.5 inches Approx. 21.5 inches
Tohatsu Approx. 17.1 inches Approx. 21.7 inches
Yamabisi Outboards Approx. 17.1 inches Approx. 21.6 inches

*Note: Measurements may vary slightly depending on the exact horsepower and model year. Always refer to your specific owner’s manual.

Share With

Latest Articles

Ink & Toner Finder

Brand
Series
Model
Get Quote